Wiphy phy0 wiphy index: 0 max # scan SSIDs: 16 max scan IEs length: 195 bytes max # sched scan SSIDs: 16 max # match sets: 16 Retry short limit: 7 Retry long limit: 4 Coverage class: 0 (up to 0m) Device supports RSN-IBSS. Device supports AP-side u-APSD. Device supports T-DLS. Supported Ciphers: * WEP40 (00-0f-ac:1) * WEP104 (00-0f-ac:5) * TKIP (00-0f-ac:2) * CCMP-128 (00-0f-ac:4) * CMAC (00-0f-ac:6) * CMAC-256 (00-0f-ac:13) * GMAC-128 (00-0f-ac:11) * GMAC-256 (00-0f-ac:12) Available Antennas: TX 0x1 RX 0x1 Configured Antennas: TX 0x1 RX 0x1 Supported interface modes: * IBSS * managed * AP * monitor * mesh point * P2P-client * P2P-GO * P2P-device Band 1: Capabilities: 0x196f RX LDPC HT20/HT40 SM Power Save disabled RX HT20 SGI RX HT40 SGI RX STBC 1-stream Max AMSDU length: 7935 bytes DSSS/CCK HT40 Maximum RX AMPDU length 65535 bytes (exponent: 0x003) Minimum RX AMPDU time spacing: 8 usec (0x06) HT TX/RX MCS rate indexes supported: 0-7 Bitrates (non-HT): * 1.0 Mbps * 2.0 Mbps (short preamble supported) * 5.5 Mbps (short preamble supported) * 11.0 Mbps (short preamble supported) * 6.0 Mbps * 9.0 Mbps * 12.0 Mbps * 18.0 Mbps * 24.0 Mbps * 36.0 Mbps * 48.0 Mbps * 54.0 Mbps Frequencies: * 2412.0 MHz [1] (20.0 dBm) * 2417.0 MHz [2] (20.0 dBm) * 2422.0 MHz [3] (20.0 dBm) * 2427.0 MHz [4] (20.0 dBm) * 2432.0 MHz [5] (20.0 dBm) * 2437.0 MHz [6] (20.0 dBm) * 2442.0 MHz [7] (20.0 dBm) * 2447.0 MHz [8] (20.0 dBm) * 2452.0 MHz [9] (20.0 dBm) * 2457.0 MHz [10] (20.0 dBm) * 2462.0 MHz [11] (20.0 dBm) * 2467.0 MHz [12] (disabled) * 2472.0 MHz [13] (disabled) * 2484.0 MHz [14] (disabled) Band 2: Capabilities: 0x196f RX LDPC HT20/HT40 SM Power Save disabled RX HT20 SGI RX HT40 SGI RX STBC 1-stream Max AMSDU length: 7935 bytes DSSS/CCK HT40 Maximum RX AMPDU length 65535 bytes (exponent: 0x003) Minimum RX AMPDU time spacing: 8 usec (0x06) HT TX/RX MCS rate indexes supported: 0-7 VHT Capabilities (0x33907132): Max MPDU length: 11454 Supported Channel Width: neither 160 nor 80+80 RX LDPC short GI (80 MHz) SU Beamformee MU Beamformee RX antenna pattern consistency TX antenna pattern consistency VHT RX MCS set: 1 streams: MCS 0-9 2 streams: not supported 3 streams: not supported 4 streams: not supported 5 streams: not supported 6 streams: not supported 7 streams: not supported 8 streams: not supported VHT RX highest supported: 0 Mbps VHT TX MCS set: 1 streams: MCS 0-9 2 streams: not supported 3 streams: not supported 4 streams: not supported 5 streams: not supported 6 streams: not supported 7 streams: not supported 8 streams: not supported VHT TX highest supported: 0 Mbps VHT extended NSS: not supported Bitrates (non-HT): * 6.0 Mbps * 9.0 Mbps * 12.0 Mbps * 18.0 Mbps * 24.0 Mbps * 36.0 Mbps * 48.0 Mbps * 54.0 Mbps Frequencies: * 5180.0 MHz [36] (30.0 dBm) (no IR) * 5200.0 MHz [40] (30.0 dBm) (no IR) * 5220.0 MHz [44] (30.0 dBm) (no IR) * 5240.0 MHz [48] (30.0 dBm) * 5260.0 MHz [52] (30.0 dBm) (no IR, radar detection) * 5280.0 MHz [56] (30.0 dBm) (no IR, radar detection) * 5300.0 MHz [60] (30.0 dBm) (no IR, radar detection) * 5320.0 MHz [64] (30.0 dBm) (no IR, radar detection) * 5500.0 MHz [100] (30.0 dBm) (no IR, radar detection) * 5520.0 MHz [104] (30.0 dBm) (no IR, radar detection) * 5540.0 MHz [108] (30.0 dBm) (no IR, radar detection) * 5560.0 MHz [112] (30.0 dBm) (no IR, radar detection) * 5580.0 MHz [116] (30.0 dBm) (no IR, radar detection) * 5600.0 MHz [120] (30.0 dBm) (no IR, radar detection) * 5620.0 MHz [124] (30.0 dBm) (no IR, radar detection) * 5640.0 MHz [128] (30.0 dBm) (no IR, radar detection) * 5660.0 MHz [132] (30.0 dBm) (no IR, radar detection) * 5680.0 MHz [136] (30.0 dBm) (no IR, radar detection) * 5700.0 MHz [140] (30.0 dBm) (no IR, radar detection) * 5720.0 MHz [144] (30.0 dBm) (no IR) * 5745.0 MHz [149] (30.0 dBm) (no IR) * 5765.0 MHz [153] (30.0 dBm) (no IR) * 5785.0 MHz [157] (30.0 dBm) (no IR) * 5805.0 MHz [161] (30.0 dBm) (no IR) * 5825.0 MHz [165] (30.0 dBm) (no IR) * 5845.0 MHz [169] (30.0 dBm) (no IR) * 5865.0 MHz [173] (disabled) Supported commands: * new_interface * set_interface * new_key * start_ap * new_station * new_mpath * set_mesh_config * set_bss * authenticate * associate * deauthenticate * disassociate * join_ibss * join_mesh * remain_on_channel * set_tx_bitrate_mask * frame * frame_wait_cancel * set_wiphy_netns * set_channel * tdls_mgmt * tdls_oper * probe_client * set_noack_map * register_beacons * start_p2p_device * set_mcast_rate * testmode * connect * disconnect * channel_switch * set_qos_map * set_multicast_to_unicast WoWLAN support: * wake up on disconnect * wake up on magic packet * wake up on pattern match, up to 22 patterns of 1-134 bytes, maximum packet offset 114 bytes * wake up on network detection, up to 16 match sets software interface modes (can always be added): * monitor valid interface combinations: * #{ managed } <= 2, #{ AP, mesh point, P2P-client, P2P-GO } <= 2, #{ P2P-device } <= 1, total <= 4, #channels <= 1 * #{ managed } <= 2, #{ P2P-client } <= 2, #{ AP, mesh point, P2P-GO } <= 1, #{ P2P-device } <= 1, total <= 4, #channels <= 2 * #{ managed } <= 1, #{ IBSS } <= 1, total <= 2, #channels <= 1 HT Capability overrides: * MCS: ff ff ff ff ff ff ff ff ff ff * maximum A-MSDU length * supported channel width * short GI for 40 MHz * max A-MPDU length exponent * min MPDU start spacing Device supports TX status socket option. Device supports HT-IBSS. Device supports SAE with AUTHENTICATE command Device supports scan flush. Device supports AP scan. Device supports per-vif TX power setting Driver supports full state transitions for AP/GO clients Driver supports a userspace MPM Driver/device bandwidth changes during BSS lifetime (AP/GO mode) Device supports static SMPS Device supports configuring vdev MAC-addr on create. Device supports randomizing MAC-addr in scans. Device supports randomizing MAC-addr in net-detect scans. max # scan plans: 2 max scan plan interval: 7200 max scan plan iterations: 100 Supported TX frame types: * IBSS: 0x00 0x10 0x20 0x30 0x40 0x50 0x60 0x70 0x80 0x90 0xa0 0xb0 0xc0 0xd0 0xe0 0xf0 * managed: 0x00 0x10 0x20 0x30 0x40 0x50 0x60 0x70 0x80 0x90 0xa0 0xb0 0xc0 0xd0 0xe0 0xf0 * AP: 0x00 0x10 0x20 0x30 0x40 0x50 0x60 0x70 0x80 0x90 0xa0 0xb0 0xc0 0xd0 0xe0 0xf0 * AP/VLAN: 0x00 0x10 0x20 0x30 0x40 0x50 0x60 0x70 0x80 0x90 0xa0 0xb0 0xc0 0xd0 0xe0 0xf0 * mesh point: 0x00 0x10 0x20 0x30 0x40 0x50 0x60 0x70 0x80 0x90 0xa0 0xb0 0xc0 0xd0 0xe0 0xf0 * P2P-client: 0x00 0x10 0x20 0x30 0x40 0x50 0x60 0x70 0x80 0x90 0xa0 0xb0 0xc0 0xd0 0xe0 0xf0 * P2P-GO: 0x00 0x10 0x20 0x30 0x40 0x50 0x60 0x70 0x80 0x90 0xa0 0xb0 0xc0 0xd0 0xe0 0xf0 * P2P-device: 0x00 0x10 0x20 0x30 0x40 0x50 0x60 0x70 0x80 0x90 0xa0 0xb0 0xc0 0xd0 0xe0 0xf0 Supported RX frame types: * IBSS: 0x40 0xb0 0xc0 0xd0 * managed: 0x40 0xb0 0xd0 * AP: 0x00 0x20 0x40 0xa0 0xb0 0xc0 0xd0 * AP/VLAN: 0x00 0x20 0x40 0xa0 0xb0 0xc0 0xd0 * mesh point: 0xb0 0xc0 0xd0 * P2P-client: 0x40 0xd0 * P2P-GO: 0x00 0x20 0x40 0xa0 0xb0 0xc0 0xd0 * P2P-device: 0x40 0xd0 Maximum associated stations in AP mode: 32 Supported extended features: * [ VHT_IBSS ]: VHT-IBSS * [ RRM ]: RRM * [ SET_SCAN_DWELL ]: scan dwell setting * [ FILS_STA ]: STA FILS (Fast Initial Link Setup) * [ CQM_RSSI_LIST ]: multiple CQM_RSSI_THOLD records * [ CONTROL_PORT_OVER_NL80211 ]: control port over nl80211 * [ TXQS ]: FQ-CoDel-enabled intermediate TXQs * [ AQL ]: Airtime Queue Limits (AQL) * [ CONTROL_PORT_NO_PREAUTH ]: disable pre-auth over nl80211 control port support * [ DEL_IBSS_STA ]: deletion of IBSS station support * [ SCAN_FREQ_KHZ ]: scan on kHz frequency support * [ CONTROL_PORT_OVER_NL80211_TX_STATUS ]: tx status for nl80211 control port support * [ POWERED_ADDR_CHANGE ]: can change MAC address while up