/dev/sda === START OF INFORMATION SECTION === Model Family: SAMSUNG SpinPoint P80 SD Device Model: SAMSUNG HD160JJ Serial Number: -- Firmware Version: ZM100-41 User Capacity: 160 041 885 696 bytes [160 GB] Sector Size: 512 bytes logical/physical Device is: In smartctl database [for details use: -P show] ATA Version is: ATA/ATAPI-7 T13/1532D revision 4a Local Time is: Fri Jan 13 02:40:36 2017 MSK SMART support is: Available - device has SMART capability. SMART support is: Enabled AAM feature is: Disabled APM feature is: Unavailable Rd look-ahead is: Enabled Write cache is: Enabled ATA Security is: Disabled, frozen [SEC2] Wt Cache Reorder: Enabled === START OF READ SMART DATA SECTION === SMART overall-health self-assessment test result: FAILED! Drive failure expected in less than 24 hours. SAVE ALL DATA. See vendor-specific Attribute list for failed Attributes. General SMART Values: Offline data collection status: (0x84) Offline data collection activity was suspended by an interrupting command from host. Auto Offline Data Collection: Enabled. Self-test execution status: ( 0) The previous self-test routine completed without error or no self-test has ever been run. Total time to complete Offline data collection: ( 3608) seconds. Offline data collection capabilities: (0x5b) SMART execute Offline immediate. Auto Offline data collection on/off support. Suspend Offline collection upon new command. Offline surface scan supported. Self-test supported. No Conveyance Self-test supported. Selective Self-test supported. SMART capabilities: (0x0003) Saves SMART data before entering power-saving mode. Supports SMART auto save timer. Error logging capability: (0x01) Error logging supported. General Purpose Logging supported. Short self-test routine recommended polling time: ( 1) minutes. Extended self-test routine recommended polling time: ( 60) minutes. SCT capabilities: (0x003f) SCT Status supported. SCT Error Recovery Control supported. SCT Feature Control supported. SCT Data Table supported. SMART Attributes Data Structure revision number: 16 Vendor Specific SMART Attributes with Thresholds: ID# ATTRIBUTE_NAME FLAGS VALUE WORST THRESH FAIL RAW_VALUE 1 Raw_Read_Error_Rate POSR-- 100 100 051 - 0 3 Spin_Up_Time POS--- 100 100 025 - 5696 4 Start_Stop_Count -O--CK 097 097 000 - 3703 5 Reallocated_Sector_Ct PO--CK 001 001 010 NOW 1798 7 Seek_Error_Rate POSR-- 253 253 051 - 0 8 Seek_Time_Performance P-S--K 253 253 015 - 0 9 Power_On_Hours -O--CK 100 100 000 - 5679 10 Spin_Retry_Count PO--CK 253 253 051 - 0 11 Calibration_Retry_Count -O--C- 253 100 000 - 0 12 Power_Cycle_Count -O--CK 098 098 000 - 2425 187 Reported_Uncorrect -O--CK 253 253 000 - 0 190 Airflow_Temperature_Cel -O---K 136 064 000 - 34 194 Temperature_Celsius -O---K 136 064 000 - 34 195 Hardware_ECC_Recovered -O-RC- 100 100 000 - 344770 196 Reallocated_Event_Count -O--CK 001 001 000 - 1798 197 Current_Pending_Sector -O--C- 253 253 000 - 0 198 Offline_Uncorrectable ----CK 253 253 000 - 0 199 UDMA_CRC_Error_Count -OSRCK 200 200 000 - 0 200 Multi_Zone_Error_Rate -O-R-- 100 100 000 - 0 201 Soft_Read_Error_Rate -O-R-- 253 100 000 - 0 202 Data_Address_Mark_Errs -O--CK 253 253 000 - 0 ||||||_ K auto-keep |||||__ C event count ||||___ R error rate |||____ S speed/performance ||_____ O updated online |______ P prefailure warning General Purpose Log Directory Version 1 SMART Log Directory Version 1 [multi-sector log support] Address Access R/W Size Description 0x00 GPL,SL R/O 1 Log Directory 0x01 SL R/O 1 Summary SMART error log 0x02 SL R/O 2 Comprehensive SMART error log 0x03 GPL R/O 2 Ext. Comprehensive SMART error log 0x06 SL R/O 1 SMART self-test log 0x10 GPL R/O 1 SATA NCQ Queued Error log 0x11 GPL R/O 1 SATA Phy Event Counters log 0x80-0x9f GPL,SL R/W 16 Host vendor specific log SMART Extended Comprehensive Error Log Version: 1 (2 sectors) Invalid Error Log index = 0x0000, trying reserved byte (0x01) instead Device Error Count: 1 CR = Command Register FEATR = Features Register COUNT = Count (was: Sector Count) Register LBA_48 = Upper bytes of LBA High/Mid/Low Registers ] ATA-8 LH = LBA High (was: Cylinder High) Register ] LBA LM = LBA Mid (was: Cylinder Low) Register ] Register LL = LBA Low (was: Sector Number) Register ] DV = Device (was: Device/Head) Register DC = Device Control Register ER = Error register ST = Status register Powered_Up_Time is measured from power on, and printed as DDd+hh:mm:SS.sss where DD=days, hh=hours, mm=minutes, SS=sec, and sss=millisec. It "wraps" after 49.710 days. Error 1 [0] occurred at disk power-on lifetime: 4466 hours (186 days + 2 hours) When the command that caused the error occurred, the device was active or idle. After command completion occurred, registers were: ER -- ST COUNT LBA_48 LH LM LL DV DC -- -- -- == -- == == == -- -- -- -- -- 04 -- 51 00 80 00 00 03 ae ee 0f e0 00 Error: ABRT 128 sectors at LBA = 0x03aeee0f = 61795855 Commands leading to the command that caused the error were: CR FEATR COUNT LBA_48 LH LM LL DV DC Powered_Up_Time Command/Feature_Name -- == -- == -- == == == -- -- -- -- -- --------------- -------------------- 35 00 00 00 80 00 00 03 ae ee 0f e0 00 01:05:04.750 WRITE DMA EXT 35 00 00 00 80 00 00 03 ae ed 8f e0 00 01:05:04.750 WRITE DMA EXT 35 00 00 00 80 00 00 03 ae ed 0f e0 00 01:05:04.750 WRITE DMA EXT 35 00 00 00 80 00 00 03 ae ec 8f e0 00 01:05:04.750 WRITE DMA EXT 35 00 00 00 80 00 00 03 ae ec 0f e0 00 01:05:04.750 WRITE DMA EXT SMART Extended Self-test Log (GP Log 0x07) not supported SMART Self-test log structure revision number 1 No self-tests have been logged. [To run self-tests, use: smartctl -t] SMART Selective self-test log data structure revision number 0 Note: revision number not 1 implies that no selective self-test has ever been run SPAN MIN_LBA MAX_LBA CURRENT_TEST_STATUS 1 0 0 Not_testing 2 0 0 Not_testing 3 0 0 Not_testing 4 0 0 Not_testing 5 0 0 Not_testing Selective self-test flags (0x0): After scanning selected spans, do NOT read-scan remainder of disk. If Selective self-test is pending on power-up, resume after 0 minute delay. SCT Status Version: 2 SCT Version (vendor specific): 256 (0x0100) SCT Support Level: 1 Device State: Active (0) Current Temperature: 34 Celsius Power Cycle Max Temperature: 34 Celsius Lifetime Max Temperature: 65 Celsius SCT Temperature History Version: 2 Temperature Sampling Period: 1 minute Temperature Logging Interval: 1 minute Min/Max recommended Temperature: 10/55 Celsius Min/Max Temperature Limit: 5/60 Celsius Temperature History Size (Index): 128 (17) Index Estimated Time Temperature Celsius 18 2017-01-13 00:33 40 ********************* 19 2017-01-13 00:34 40 ********************* 20 2017-01-13 00:35 42 *********************** ... ..( 3 skipped). .. *********************** 24 2017-01-13 00:39 42 *********************** 25 2017-01-13 00:40 40 ********************* ... ..( 28 skipped). .. ********************* 54 2017-01-13 01:09 40 ********************* 55 2017-01-13 01:10 44 ************************* ... ..( 3 skipped). .. ************************* 59 2017-01-13 01:14 44 ************************* 60 2017-01-13 01:15 40 ********************* ... ..( 28 skipped). .. ********************* 89 2017-01-13 01:44 40 ********************* 90 2017-01-13 01:45 ? - 91 2017-01-13 01:46 24 ***** 92 2017-01-13 01:47 26 ******* 93 2017-01-13 01:48 22 *** 94 2017-01-13 01:49 22 *** 95 2017-01-13 01:50 24 ***** ... ..( 2 skipped). .. ***** 98 2017-01-13 01:53 24 ***** 99 2017-01-13 01:54 23 **** ... ..( 4 skipped). .. **** 104 2017-01-13 01:59 23 **** 105 2017-01-13 02:00 30 *********** 106 2017-01-13 02:01 ? - 107 2017-01-13 02:02 20 * 108 2017-01-13 02:03 20 * 109 2017-01-13 02:04 18 - 110 2017-01-13 02:05 18 - 111 2017-01-13 02:06 18 - 112 2017-01-13 02:07 20 * 113 2017-01-13 02:08 20 * 114 2017-01-13 02:09 22 *** 115 2017-01-13 02:10 21 ** ... ..( 4 skipped). .. ** 120 2017-01-13 02:15 21 ** 121 2017-01-13 02:16 23 **** ... ..( 3 skipped). .. **** 125 2017-01-13 02:20 23 **** 126 2017-01-13 02:21 30 *********** ... ..( 3 skipped). .. *********** 2 2017-01-13 02:25 30 *********** 3 2017-01-13 02:26 32 ************* ... ..( 8 skipped). .. ************* 12 2017-01-13 02:35 32 ************* 13 2017-01-13 02:36 34 *************** ... ..( 3 skipped). .. *************** 17 2017-01-13 02:40 34 *************** SCT Error Recovery Control: Read: Disabled Write: Disabled Device Statistics (GP/SMART Log 0x04) not supported SATA Phy Event Counters (GP Log 0x11) ID Size Value Description 0x0001 2 0 Command failed due to ICRC error 0x000a 2 0 Device-to-host register FISes sent due to a COMRESET 0x0008 2 0 Device-to-host non-data FIS retries 0x0009 2 0 Transition from drive PhyRdy to drive PhyNRdy 0x000b 2 0 CRC errors within host-to-device FIS 0x000d 2 0 Non-CRC errors within host-to-device FIS 0x8001 2 0 Vendor specific