/dev/sda smartctl 7.2 2020-12-30 r5155 [x86_64-linux-5.15.0-58-generic] (local build) Copyright (C) 2002-20, Bruce Allen, Christian Franke, www.smartmontools.org === START OF INFORMATION SECTION === Device Model: SAMSUNG PM881 SATA 512GB Serial Number: -- LU WWN Device Id: 5 002538 ... Firmware Version: 15300009 User Capacity: 512,110,190,592 bytes [512 GB] Sector Size: 512 bytes logical/physical Rotation Rate: Solid State Device Form Factor: 2.5 inches TRIM Command: Available Device is: Not in smartctl database [for details use: -P showall] ATA Version is: ACS-4 T13/BSR INCITS 529 revision 5 SATA Version is: SATA 3.3, 6.0 Gb/s (current: 6.0 Gb/s) Local Time is: Mon Feb 6 15:42:53 2023 CET SMART support is: Available - device has SMART capability. SMART support is: Enabled AAM feature is: Unavailable APM feature is: Unavailable Rd look-ahead is: Enabled Write cache is: Enabled DSN feature is: Unavailable ATA Security is: Disabled, frozen [SEC2] Wt Cache Reorder: Enabled === START OF READ SMART DATA SECTION === SMART overall-health self-assessment test result: PASSED General SMART Values: Offline data collection status: (0x00) Offline data collection activity was never started. Auto Offline Data Collection: Disabled. Self-test execution status: ( 0) The previous self-test routine completed without error or no self-test has ever been run. Total time to complete Offline data collection: ( 0) seconds. Offline data collection capabilities: (0x53) SMART execute Offline immediate. Auto Offline data collection on/off support. Suspend Offline collection upon new command. No Offline surface scan supported. Self-test supported. No Conveyance Self-test supported. Selective Self-test supported. SMART capabilities: (0x0003) Saves SMART data before entering power-saving mode. Supports SMART auto save timer. Error logging capability: (0x01) Error logging supported. General Purpose Logging supported. Short self-test routine recommended polling time: ( 2) minutes. Extended self-test routine recommended polling time: ( 85) minutes. SCT capabilities: (0x003d) SCT Status supported. SCT Error Recovery Control supported. SCT Feature Control supported. SCT Data Table supported. SMART Attributes Data Structure revision number: 1 Vendor Specific SMART Attributes with Thresholds: ID# ATTRIBUTE_NAME FLAGS VALUE WORST THRESH FAIL RAW_VALUE 5 Reallocated_Sector_Ct PO--CK 100 100 010 - 0 9 Power_On_Hours -O--CK 099 099 000 - 430 12 Power_Cycle_Count PO--CK 099 099 000 - 59 175 Program_Fail_Count_Chip PO--CK 100 100 010 - 0 176 Erase_Fail_Count_Chip PO--CK 100 100 010 - 0 177 Wear_Leveling_Count PO--C- 100 100 005 - 0 178 Used_Rsvd_Blk_Cnt_Chip PO--C- 100 100 010 - 0 179 Used_Rsvd_Blk_Cnt_Tot PO--C- 100 100 010 - 0 180 Unused_Rsvd_Blk_Cnt_Tot PO--C- 100 100 010 - 994 181 Program_Fail_Cnt_Total PO--CK 100 100 010 - 0 182 Erase_Fail_Count_Total PO--CK 100 100 010 - 0 187 Reported_Uncorrect PO--CK 100 100 000 - 0 194 Temperature_Celsius PO--CK 078 063 000 - 22 195 Hardware_ECC_Recovered PO-RC- 200 200 000 - 0 199 UDMA_CRC_Error_Count -OSRCK 100 100 000 - 0 238 Unknown_Attribute -O--C- 100 100 000 - 100 241 Total_LBAs_Written PO--CK 099 099 000 - 386369478 242 Total_LBAs_Read PO--CK 099 099 000 - 128431067 ||||||_ K auto-keep |||||__ C event count ||||___ R error rate |||____ S speed/performance ||_____ O updated online |______ P prefailure warning General Purpose Log Directory Version 1 SMART Log Directory Version 1 [multi-sector log support] Address Access R/W Size Description 0x00 GPL,SL R/O 1 Log Directory 0x01 SL R/O 1 Summary SMART error log 0x02 SL R/O 1 Comprehensive SMART error log 0x03 GPL R/O 1 Ext. Comprehensive SMART error log 0x04 GPL,SL R/O 8 Device Statistics log 0x06 SL R/O 1 SMART self-test log 0x07 GPL R/O 1 Extended self-test log 0x09 SL R/W 1 Selective self-test log 0x10 GPL R/O 1 NCQ Command Error log 0x11 GPL R/O 1 SATA Phy Event Counters log 0x13 GPL R/O 1 SATA NCQ Send and Receive log 0x30 GPL,SL R/O 9 IDENTIFY DEVICE data log 0x80-0x9f GPL,SL R/W 16 Host vendor specific log 0xa5 SL VS 16 Device vendor specific log 0xce SL VS 16 Device vendor specific log 0xe0 GPL,SL R/W 1 SCT Command/Status 0xe1 GPL,SL R/W 1 SCT Data Transfer SMART Extended Comprehensive Error Log Version: 1 (1 sectors) No Errors Logged SMART Extended Self-test Log Version: 1 (1 sectors) Num Test_Description Status Remaining LifeTime(hours) LBA_of_first_error # 1 Short offline Completed without error 00% 0 - SMART Selective self-test log data structure revision number 1 SPAN MIN_LBA MAX_LBA CURRENT_TEST_STATUS 1 0 0 Not_testing 2 0 0 Not_testing 3 0 0 Not_testing 4 0 0 Not_testing 5 0 0 Not_testing 256 0 65535 Read_scanning was never started Selective self-test flags (0x0): After scanning selected spans, do NOT read-scan remainder of disk. If Selective self-test is pending on power-up, resume after 0 minute delay. SCT Status Version: 3 SCT Version (vendor specific): 256 (0x0100) Device State: Active (0) Current Temperature: 22 Celsius Power Cycle Min/Max Temperature: 13/21 Celsius Lifetime Min/Max Temperature: 13/31 Celsius Specified Max Operating Temperature: 70 Celsius Under/Over Temperature Limit Count: 0/0 SMART Status: 0xc24f (PASSED) SCT Temperature History Version: 2 Temperature Sampling Period: 10 minutes Temperature Logging Interval: 10 minutes Min/Max recommended Temperature: 0/70 Celsius Min/Max Temperature Limit: 0/70 Celsius Temperature History Size (Index): 128 (95) Index Estimated Time Temperature Celsius 96 2023-02-05 18:30 20 * 97 2023-02-05 18:40 21 ** ... ..( 2 skipped). .. ** 100 2023-02-05 19:10 21 ** 101 2023-02-05 19:20 20 * ... ..( 6 skipped). .. * 108 2023-02-05 20:30 20 * 109 2023-02-05 20:40 21 ** ... ..( 25 skipped). .. ** 7 2023-02-06 01:00 21 ** 8 2023-02-06 01:10 ? - 9 2023-02-06 01:20 18 - 10 2023-02-06 01:30 19 - ... ..( 10 skipped). .. - 21 2023-02-06 03:20 19 - 22 2023-02-06 03:30 20 * 23 2023-02-06 03:40 21 ** ... ..( 2 skipped). .. ** 26 2023-02-06 04:10 21 ** 27 2023-02-06 04:20 20 * ... ..( 10 skipped). .. * 38 2023-02-06 06:10 20 * 39 2023-02-06 06:20 21 ** ... ..( 5 skipped). .. ** 45 2023-02-06 07:20 21 ** 46 2023-02-06 07:30 22 *** 47 2023-02-06 07:40 22 *** 48 2023-02-06 07:50 21 ** ... ..( 6 skipped). .. ** 55 2023-02-06 09:00 21 ** 56 2023-02-06 09:10 ? - 57 2023-02-06 09:20 18 - 58 2023-02-06 09:30 17 - 59 2023-02-06 09:40 18 - 60 2023-02-06 09:50 18 - 61 2023-02-06 10:00 18 - 62 2023-02-06 10:10 19 - ... ..( 3 skipped). .. - 66 2023-02-06 10:50 19 - 67 2023-02-06 11:00 20 * ... ..( 2 skipped). .. * 70 2023-02-06 11:30 20 * 71 2023-02-06 11:40 21 ** ... ..( 8 skipped). .. ** 80 2023-02-06 13:10 21 ** 81 2023-02-06 13:20 20 * 82 2023-02-06 13:30 20 * 83 2023-02-06 13:40 20 * 84 2023-02-06 13:50 21 ** ... ..( 10 skipped). .. ** 95 2023-02-06 15:40 21 ** SCT Error Recovery Control: Read: Disabled Write: Disabled Device Statistics (GP Log 0x04) Page Offset Size Value Flags Description 0x01 ===== = = === == General Statistics (rev 1) == 0x01 0x008 4 59 --- Lifetime Power-On Resets 0x01 0x010 4 430 --- Power-on Hours 0x01 0x018 6 386369478 --- Logical Sectors Written 0x01 0x020 6 4459469 --- Number of Write Commands 0x01 0x028 6 128431067 --- Logical Sectors Read 0x01 0x030 6 1722604 --- Number of Read Commands 0x01 0x038 6 963000 --- Date and Time TimeStamp 0x04 ===== = = === == General Errors Statistics (rev 1) == 0x04 0x008 4 0 --- Number of Reported Uncorrectable Errors 0x04 0x010 4 0 --- Resets Between Cmd Acceptance and Completion 0x05 ===== = = === == Temperature Statistics (rev 1) == 0x05 0x008 1 22 --- Current Temperature 0x05 0x020 1 31 --- Highest Temperature 0x05 0x028 1 13 --- Lowest Temperature 0x05 0x058 1 70 --- Specified Maximum Operating Temperature 0x06 ===== = = === == Transport Statistics (rev 1) == 0x06 0x008 4 150 --- Number of Hardware Resets 0x06 0x010 4 0 --- Number of ASR Events 0x06 0x018 4 0 --- Number of Interface CRC Errors 0x07 ===== = = === == Solid State Device Statistics (rev 1) == 0x07 0x008 1 0 N-- Percentage Used Endurance Indicator |||_ C monitored condition met ||__ D supports DSN |___ N normalized value Pending Defects log (GP Log 0x0c) not supported SATA Phy Event Counters (GP Log 0x11) ID Size Value Description 0x0001 2 0 Command failed due to ICRC error 0x0002 2 0 R_ERR response for data FIS 0x0003 2 0 R_ERR response for device-to-host data FIS 0x0004 2 0 R_ERR response for host-to-device data FIS 0x0005 2 0 R_ERR response for non-data FIS 0x0006 2 0 R_ERR response for device-to-host non-data FIS 0x0007 2 0 R_ERR response for host-to-device non-data FIS 0x0008 2 0 Device-to-host non-data FIS retries 0x0009 2 6 Transition from drive PhyRdy to drive PhyNRdy 0x000a 2 6 Device-to-host register FISes sent due to a COMRESET 0x000b 2 0 CRC errors within host-to-device FIS 0x000d 2 0 Non-CRC errors within host-to-device FIS 0x000f 2 0 R_ERR response for host-to-device data FIS, CRC 0x0010 2 0 R_ERR response for host-to-device data FIS, non-CRC 0x0012 2 0 R_ERR response for host-to-device non-data FIS, CRC 0x0013 2 0 R_ERR response for host-to-device non-data FIS, non-CRC