/dev/sda === START OF INFORMATION SECTION === Model Family: Hitachi Deskstar 7K160 Device Model: Hitachi HDS721616PLA380 Serial Number: -- LU WWN Device Id: 5 000cca ... Firmware Version: P22OAB3A User Capacity: 164 696 555 520 bytes [164 GB] Sector Size: 512 bytes logical/physical Device is: In smartctl database [for details use: -P show] ATA Version is: ATA/ATAPI-7 T13/1532D revision 1 Local Time is: Sun May 21 19:05:24 2017 MSK SMART support is: Available - device has SMART capability. SMART support is: Enabled AAM feature is: Disabled APM feature is: Disabled Rd look-ahead is: Enabled Write cache is: Enabled ATA Security is: Disabled, frozen [SEC2] Wt Cache Reorder: Enabled === START OF READ SMART DATA SECTION === SMART overall-health self-assessment test result: PASSED General SMART Values: Offline data collection status: (0x80) Offline data collection activity was never started. Auto Offline Data Collection: Enabled. Self-test execution status: ( 0) The previous self-test routine completed without error or no self-test has ever been run. Total time to complete Offline data collection: ( 2865) seconds. Offline data collection capabilities: (0x5b) SMART execute Offline immediate. Auto Offline data collection on/off support. Suspend Offline collection upon new command. Offline surface scan supported. Self-test supported. No Conveyance Self-test supported. Selective Self-test supported. SMART capabilities: (0x0003) Saves SMART data before entering power-saving mode. Supports SMART auto save timer. Error logging capability: (0x01) Error logging supported. General Purpose Logging supported. Short self-test routine recommended polling time: ( 1) minutes. Extended self-test routine recommended polling time: ( 48) minutes. SCT capabilities: (0x003f) SCT Status supported. SCT Error Recovery Control supported. SCT Feature Control supported. SCT Data Table supported. SMART Attributes Data Structure revision number: 16 Vendor Specific SMART Attributes with Thresholds: ID# ATTRIBUTE_NAME FLAGS VALUE WORST THRESH FAIL RAW_VALUE 1 Raw_Read_Error_Rate PO-R-- 100 100 016 - 0 2 Throughput_Performance P-S--- 100 100 050 - 0 3 Spin_Up_Time POS--- 131 131 024 - 145 (Average 160) 4 Start_Stop_Count -O--C- 099 099 000 - 6834 5 Reallocated_Sector_Ct PO--CK 100 100 005 - 0 7 Seek_Error_Rate PO-R-- 100 100 067 - 0 8 Seek_Time_Performance P-S--- 100 100 020 - 0 9 Power_On_Hours -O--C- 097 097 000 - 22044 10 Spin_Retry_Count PO--C- 100 100 060 - 0 12 Power_Cycle_Count -O--CK 099 099 000 - 6707 192 Power-Off_Retract_Count -O--CK 094 094 000 - 7205 193 Load_Cycle_Count -O--C- 094 094 000 - 7205 194 Temperature_Celsius -O---- 150 150 000 - 40 (Min/Max 14/57) 196 Reallocated_Event_Count -O--CK 100 100 000 - 0 197 Current_Pending_Sector -O---K 100 100 000 - 0 198 Offline_Uncorrectable ---R-- 100 100 000 - 0 199 UDMA_CRC_Error_Count -O-R-- 200 253 000 - 0 ||||||_ K auto-keep |||||__ C event count ||||___ R error rate |||____ S speed/performance ||_____ O updated online |______ P prefailure warning General Purpose Log Directory Version 1 SMART Log Directory Version 1 [multi-sector log support] Address Access R/W Size Description 0x00 GPL,SL R/O 1 Log Directory 0x01 SL R/O 1 Summary SMART error log 0x03 GPL R/O 1 Ext. Comprehensive SMART error log 0x06 SL R/O 1 SMART self-test log 0x07 GPL R/O 1 Extended self-test log 0x09 SL R/W 1 Selective self-test log 0x10 GPL R/O 1 SATA NCQ Queued Error log 0x11 GPL R/O 1 SATA Phy Event Counters log 0x20 GPL R/O 1 Streaming performance log [OBS-8] 0x21 GPL R/O 1 Write stream error log 0x22 GPL R/O 1 Read stream error log 0x80-0x9f GPL,SL R/W 16 Host vendor specific log 0xe0 GPL,SL R/W 1 SCT Command/Status 0xe1 GPL,SL R/W 1 SCT Data Transfer SMART Extended Comprehensive Error Log Version: 1 (1 sectors) No Errors Logged SMART Extended Self-test Log Version: 1 (1 sectors) No self-tests have been logged. [To run self-tests, use: smartctl -t] SMART Selective self-test log data structure revision number 1 SPAN MIN_LBA MAX_LBA CURRENT_TEST_STATUS 1 0 0 Not_testing 2 0 0 Not_testing 3 0 0 Not_testing 4 0 0 Not_testing 5 0 0 Not_testing Selective self-test flags (0x0): After scanning selected spans, do NOT read-scan remainder of disk. If Selective self-test is pending on power-up, resume after 0 minute delay. SCT Status Version: 2 SCT Version (vendor specific): 256 (0x0100) SCT Support Level: 1 Device State: Active (0) Current Temperature: 40 Celsius Power Cycle Max Temperature: 40 Celsius Lifetime Max Temperature: 57 Celsius SCT Temperature History Version: 2 Temperature Sampling Period: 1 minute Temperature Logging Interval: 1 minute Min/Max recommended Temperature: 5/60 Celsius Min/Max Temperature Limit: -40/65 Celsius Temperature History Size (Index): 128 (69) Index Estimated Time Temperature Celsius 70 2017-05-21 16:58 43 ************************ 71 2017-05-21 16:59 43 ************************ 72 2017-05-21 17:00 43 ************************ 73 2017-05-21 17:01 42 *********************** ... ..( 28 skipped). .. *********************** 102 2017-05-21 17:30 42 *********************** 103 2017-05-21 17:31 43 ************************ 104 2017-05-21 17:32 42 *********************** ... ..( 59 skipped). .. *********************** 36 2017-05-21 18:32 42 *********************** 37 2017-05-21 18:33 ? - 38 2017-05-21 18:34 25 ****** 39 2017-05-21 18:35 28 ********* 40 2017-05-21 18:36 30 *********** 41 2017-05-21 18:37 31 ************ 42 2017-05-21 18:38 32 ************* 43 2017-05-21 18:39 33 ************** 44 2017-05-21 18:40 34 *************** 45 2017-05-21 18:41 35 **************** 46 2017-05-21 18:42 35 **************** 47 2017-05-21 18:43 35 **************** 48 2017-05-21 18:44 36 ***************** 49 2017-05-21 18:45 36 ***************** 50 2017-05-21 18:46 37 ****************** 51 2017-05-21 18:47 38 ******************* ... ..( 6 skipped). .. ******************* 58 2017-05-21 18:54 38 ******************* 59 2017-05-21 18:55 39 ******************** ... ..( 6 skipped). .. ******************** 66 2017-05-21 19:02 39 ******************** 67 2017-05-21 19:03 40 ********************* 68 2017-05-21 19:04 40 ********************* 69 2017-05-21 19:05 40 ********************* SCT Error Recovery Control: Read: Disabled Write: Disabled Device Statistics (GP/SMART Log 0x04) not supported SATA Phy Event Counters (GP Log 0x11) ID Size Value Description 0x0001 2 0 Command failed due to ICRC error 0x0009 2 14 Transition from drive PhyRdy to drive PhyNRdy 0x000a 2 14 Device-to-host register FISes sent due to a COMRESET 0x000b 2 0 CRC errors within host-to-device FIS 0x000d 2 0 Non-CRC errors within host-to-device FIS