/dev/sda === START OF INFORMATION SECTION === Model Family: Western Digital Scorpio Blue Serial ATA (AF) Device Model: WDC WD3200BPVT-22JJ5T0 Serial Number: -- LU WWN Device Id: 5 0014ee ... Firmware Version: 01.01A01 User Capacity: 320 072 933 376 bytes [320 GB] Sector Sizes: 512 bytes logical, 4096 bytes physical Rotation Rate: 5400 rpm Device is: In smartctl database [for details use: -P show] ATA Version is: ATA8-ACS (minor revision not indicated) SATA Version is: SATA 2.6, 3.0 Gb/s Local Time is: Fri Dec 7 20:37:28 2018 MSK SMART support is: Available - device has SMART capability. SMART support is: Enabled AAM feature is: Unavailable APM level is: 96 (intermediate level with standby) Rd look-ahead is: Enabled Write cache is: Enabled ATA Security is: Disabled, frozen [SEC2] Wt Cache Reorder: Enabled === START OF READ SMART DATA SECTION === SMART overall-health self-assessment test result: PASSED General SMART Values: Offline data collection status: (0x82) Offline data collection activity was completed without error. Auto Offline Data Collection: Enabled. Self-test execution status: ( 0) The previous self-test routine completed without error or no self-test has ever been run. Total time to complete Offline data collection: ( 7200) seconds. Offline data collection capabilities: (0x7b) SMART execute Offline immediate. Auto Offline data collection on/off support. Suspend Offline collection upon new command. Offline surface scan supported. Self-test supported. Conveyance Self-test supported. Selective Self-test supported. SMART capabilities: (0x0003) Saves SMART data before entering power-saving mode. Supports SMART auto save timer. Error logging capability: (0x01) Error logging supported. General Purpose Logging supported. Short self-test routine recommended polling time: ( 2) minutes. Extended self-test routine recommended polling time: ( 74) minutes. Conveyance self-test routine recommended polling time: ( 5) minutes. SCT capabilities: (0x7035) SCT Status supported. SCT Feature Control supported. SCT Data Table supported. SMART Attributes Data Structure revision number: 16 Vendor Specific SMART Attributes with Thresholds: ID# ATTRIBUTE_NAME FLAGS VALUE WORST THRESH FAIL RAW_VALUE 1 Raw_Read_Error_Rate POSR-K 200 200 051 - 0 3 Spin_Up_Time POS--K 142 136 021 - 1883 4 Start_Stop_Count -O--CK 001 001 000 - 161263 5 Reallocated_Sector_Ct PO--CK 200 200 140 - 0 7 Seek_Error_Rate -OSR-K 200 200 000 - 0 9 Power_On_Hours -O--CK 057 057 000 - 31588 10 Spin_Retry_Count -O--CK 100 100 000 - 0 11 Calibration_Retry_Count -O--CK 100 100 000 - 0 12 Power_Cycle_Count -O--CK 097 097 000 - 3811 191 G-Sense_Error_Rate -O--CK 001 001 000 - 5313 192 Power-Off_Retract_Count -O--CK 199 199 000 - 824 193 Load_Cycle_Count -O--CK 001 001 000 - 5593934 194 Temperature_Celsius -O---K 101 090 000 - 42 196 Reallocated_Event_Count -O--CK 200 200 000 - 0 197 Current_Pending_Sector -O--CK 200 200 000 - 0 198 Offline_Uncorrectable ----CK 200 200 000 - 0 199 UDMA_CRC_Error_Count -O--CK 200 200 000 - 0 200 Multi_Zone_Error_Rate ---R-- 200 200 000 - 0 ||||||_ K auto-keep |||||__ C event count ||||___ R error rate |||____ S speed/performance ||_____ O updated online |______ P prefailure warning General Purpose Log Directory Version 1 SMART Log Directory Version 1 [multi-sector log support] Address Access R/W Size Description 0x00 GPL,SL R/O 1 Log Directory 0x01 SL R/O 1 Summary SMART error log 0x02 SL R/O 5 Comprehensive SMART error log 0x03 GPL R/O 6 Ext. Comprehensive SMART error log 0x06 SL R/O 1 SMART self-test log 0x07 GPL R/O 1 Extended self-test log 0x09 SL R/W 1 Selective self-test log 0x10 GPL R/O 1 SATA NCQ Queued Error log 0x11 GPL R/O 1 SATA Phy Event Counters log 0x80-0x9f GPL,SL R/W 16 Host vendor specific log 0xa0-0xa7 GPL,SL VS 16 Device vendor specific log 0xa8-0xb7 GPL,SL VS 1 Device vendor specific log 0xbd GPL,SL VS 1 Device vendor specific log 0xc0 GPL,SL VS 1 Device vendor specific log 0xc1 GPL VS 93 Device vendor specific log 0xe0 GPL,SL R/W 1 SCT Command/Status 0xe1 GPL,SL R/W 1 SCT Data Transfer SMART Extended Comprehensive Error Log Version: 1 (6 sectors) No Errors Logged SMART Extended Self-test Log Version: 1 (1 sectors) No self-tests have been logged. [To run self-tests, use: smartctl -t] SMART Selective self-test log data structure revision number 1 SPAN MIN_LBA MAX_LBA CURRENT_TEST_STATUS 1 0 0 Not_testing 2 0 0 Not_testing 3 0 0 Not_testing 4 0 0 Not_testing 5 0 0 Not_testing Selective self-test flags (0x0): After scanning selected spans, do NOT read-scan remainder of disk. If Selective self-test is pending on power-up, resume after 0 minute delay. SCT Status Version: 3 SCT Version (vendor specific): 258 (0x0102) SCT Support Level: 1 Device State: Active (0) Current Temperature: 43 Celsius Power Cycle Min/Max Temperature: 41/43 Celsius Lifetime Min/Max Temperature: 0/54 Celsius Under/Over Temperature Limit Count: 0/0 Vendor specific: 01 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 SCT Temperature History Version: 2 Temperature Sampling Period: 1 minute Temperature Logging Interval: 1 minute Min/Max recommended Temperature: 0/60 Celsius Min/Max Temperature Limit: -41/85 Celsius Temperature History Size (Index): 128 (55) Index Estimated Time Temperature Celsius 56 2018-12-07 18:30 40 ********************* ... ..( 4 skipped). .. ********************* 61 2018-12-07 18:35 40 ********************* 62 2018-12-07 18:36 41 ********************** ... ..( 11 skipped). .. ********************** 74 2018-12-07 18:48 41 ********************** 75 2018-12-07 18:49 40 ********************* ... ..( 5 skipped). .. ********************* 81 2018-12-07 18:55 40 ********************* 82 2018-12-07 18:56 39 ******************** ... ..( 14 skipped). .. ******************** 97 2018-12-07 19:11 39 ******************** 98 2018-12-07 19:12 40 ********************* 99 2018-12-07 19:13 40 ********************* 100 2018-12-07 19:14 40 ********************* 101 2018-12-07 19:15 41 ********************** ... ..( 6 skipped). .. ********************** 108 2018-12-07 19:22 41 ********************** 109 2018-12-07 19:23 42 *********************** ... ..( 3 skipped). .. *********************** 113 2018-12-07 19:27 42 *********************** 114 2018-12-07 19:28 41 ********************** ... ..( 10 skipped). .. ********************** 125 2018-12-07 19:39 41 ********************** 126 2018-12-07 19:40 40 ********************* 127 2018-12-07 19:41 ? - 0 2018-12-07 19:42 40 ********************* 1 2018-12-07 19:43 40 ********************* 2 2018-12-07 19:44 ? - 3 2018-12-07 19:45 39 ******************** 4 2018-12-07 19:46 39 ******************** 5 2018-12-07 19:47 ? - 6 2018-12-07 19:48 39 ******************** 7 2018-12-07 19:49 39 ******************** 8 2018-12-07 19:50 39 ******************** 9 2018-12-07 19:51 40 ********************* ... ..( 6 skipped). .. ********************* 16 2018-12-07 19:58 40 ********************* 17 2018-12-07 19:59 41 ********************** ... ..( 6 skipped). .. ********************** 24 2018-12-07 20:06 41 ********************** 25 2018-12-07 20:07 42 *********************** 26 2018-12-07 20:08 42 *********************** 27 2018-12-07 20:09 ? - 28 2018-12-07 20:10 42 *********************** 29 2018-12-07 20:11 42 *********************** 30 2018-12-07 20:12 42 *********************** 31 2018-12-07 20:13 41 ********************** 32 2018-12-07 20:14 ? - 33 2018-12-07 20:15 41 ********************** ... ..( 8 skipped). .. ********************** 42 2018-12-07 20:24 41 ********************** 43 2018-12-07 20:25 42 *********************** ... ..( 2 skipped). .. *********************** 46 2018-12-07 20:28 42 *********************** 47 2018-12-07 20:29 43 ************************ ... ..( 7 skipped). .. ************************ 55 2018-12-07 20:37 43 ************************ SCT Error Recovery Control command not supported Device Statistics (GP/SMART Log 0x04) not supported SATA Phy Event Counters (GP Log 0x11) ID Size Value Description 0x0001 2 0 Command failed due to ICRC error 0x0002 2 0 R_ERR response for data FIS 0x0003 2 0 R_ERR response for device-to-host data FIS 0x0004 2 0 R_ERR response for host-to-device data FIS 0x0005 2 0 R_ERR response for non-data FIS 0x0006 2 0 R_ERR response for device-to-host non-data FIS 0x0007 2 0 R_ERR response for host-to-device non-data FIS 0x0008 2 0 Device-to-host non-data FIS retries 0x0009 2 4 Transition from drive PhyRdy to drive PhyNRdy 0x000a 2 2 Device-to-host register FISes sent due to a COMRESET 0x000b 2 0 CRC errors within host-to-device FIS 0x000f 2 0 R_ERR response for host-to-device data FIS, CRC 0x0012 2 0 R_ERR response for host-to-device non-data FIS, CRC 0x8000 4 1542 Vendor specific